Netgear Orbi AC2200 Router – an excellent choice for those who want to eliminate dead spots and buffering for super-fast and uninterrupted WiFi connection! However, even after the proper setup, users come across various WiFi connectivity issues with the AC2200 router.
Web pages that take ages to load test your patience a lot. Slow WiFi speeds can turn more thwarting when you need your work to be finished urgently. In such a scenario, most of us consider Orbi factory reset to resolve the problem. But, before you do that, it is suggested to check your internet connection as well as the router.
Below-given are some possible reasons that cause your Netgear Orbi AC2200 router drop the WiFi connection. Allow us to help you fix them.
Fix: Orbi AC2200 Keeps Dropping the WiFi Connection
-
Distance Between Your Orbi AC2200 Router and WiFi Device
The farther the device’s distance from the router, the weaker the WiFi speed and drop in signal.
Therefore, relocate your WiFi-enabled device closer to your Orbi router. In case that’s not possible due to your building construction, opt for an Ethernet cable to connect your WiFi router to the device.
-
Blockers – Disrupt the WiFi Signal
Give your Orbi router some space to breath. Do not keep your Netgear Orbi AC2200 behind an almirah, in a corner, insider a cabinet, and under a table. These act as barriers that block the WiFi signal incoming from your router.
More walls, less signal. This is because some construction materials avert the signals back and some absorb the signals. So, try to place your router in an open and clean area.
-
Interference from Your Neighbors’ WiFi Routers
In the event that you are residing in a densely populated area like apartments, then you may experience more WiFi congestion.
A majority of routers are by default set to follow a particular channel and frequency. Consequently, your signal conflicts with all other routers’ signal. The ultimate way to get your Orbi AC2200 router signal out of this conflict is to change its WiFi channel.
To do so, merely visit orbilogin com web page. You will be redirected to the Netgear Orbi AC2200 setup page. Once there, change the WiFi channels to 1, 6, and 11 for the 2.4 GHz bandwidth. Besides, assure that your neighbors are not hogging your WiFi bandwidth.
Important Note: Your internet speed can differ in accordance with your broadband plan. So, prior to performing another troubleshooting measure, you should talk about the speed drop issue with your Internet Service Provider (ISP).
-
Radio Frequency Devices
Cordless phones, wireless security cameras, microwaves, and Bluetooth speakers – all function on the similar radio frequency as that of your router and thus lower your Orbi router’s speed.
Wireless devices that are making use of the same frequency i.e. 2.4 GHz can result in a ‘traffic jam’ and contribute to slow WiFi.
-
The Last Resort – Reset
Tried all the aforementioned steps but nothing has resolved your Netgear Orbi AC2200 router keeps dropping the connection error? If you nod in yes, it’s time to reset your Orbi router back to the factory default settings by following the steps below:
-
Take a small paper clip or pin-like tool.
-
Plug in your AC2200 Orbi router to a wall socket.
-
Let the LEDs on it to become solid green.
-
Now, at the back panel of your Orbi router, you will locate a factory reset hole.
-
Insert the paper pin inside it and press the reset button.
That’s it! Your Orbi AC2200 reset process is completed here. Now, simply you have to do the Netgear Orbi setup once again.
So, these were some of the common reasons behind ‘Orbi AC2200 router dropping connection’ issue and relevant troubleshooting tips to fix them. Hopefully, the issue has now resolved for you.
